Discover our metering system on 2 seals.

The sealing of flanges, engine cases, turbines and other mechanical components is a process that should not be overlooked. The importance of this phase consists precisely in finding the right dispensing amount, to prevent any leaks or contaminations due to a scarce or too abundant dispensing, and this requires a great care. Depending on the various cases, the sealant ca...

Thanks to the impregnation process of windings in the electric motors, you can get many advantages. Indeed, this procedure allows to obtain a better mechanical resistance, a better heat exchange and electrical insulation, allowing you to maximize the operative performance over time. How is this process evolving? If previously the impregnation was reduced to a simple dri...

The dispensing of mono-component epoxy resins is used for various sectors for which an electro-mechanical assembly of components is envisaged, with the purpose in particular of sealing / gluing the latter; from the bonding of magnets, to the impregnation of structural components of the composite, from the incorporation of electronic components to the fixing of parts in d...

The PCP volumetric pumps, available in 6 different sizes, allow the perfect choice for any application, allowing you to dispense fluids with various types of viscosity with maximum repeatability. Controlled by a Controller, which through its dedicated software, allows you to set and monitor all the dispensing parameters and thanks to the external interface it is possible...