#Product Trends
Common faults and solutions belt filter press
Common faults and solutions belt filter press
1. conveyor belt slipping
The reason is that the belt tension is small or the surface of the drive roller is stuck with material or moisture. The screw should be tightened tightly to increase the tension. Clean the drive roller and increase the cleaning force of the empty cleaner.
2. The conveyor belt runs off at both ends
The reason is skewed roller assembly position, the screw should be tightened tensioning device to adjust the deflection pulleys side deviation position. Adjust the position of the drive roller by adjusting the bearing housing.
3. The conveyor belt runs off in the middle
The reason is that the roller is not installed correctly. Check whether the mounting position of each roller is perpendicular to the conveyor belt. Otherwise, loosen the mounting bolts to adjust the roller position. After adjustment, tighten the bolts.
In addition, the feed point drop point is not at the center of the conveyor belt and may cause deviation, and the feed should be improved.
