Tips for installation of wood CNC Router

Tips for installation of wood CNC Router: 2. Disassemble the packing box 3. Install the machine

2. Disassemble the packing box

After choosing a suitable placement position, the next thing we have to do is to open the packing box of the machine. At this time, we need to check whether the machine is damaged, and then check whether the appearance of the whole machine is scratched and whether the accessories are complete.

3. Install the machine

Installing the machine is also the focus of our talk this time. First we have to talk about the overall installation process of the machine.

3.1. First place the engraving machine on the flat ground. The four corners of the engraving body need to be adjusted and leveled. It is recommended to use a spirit level to adjust the table-top to level.

3.2. Fix the suction tube bracket on the side of the machine head and bed bracket respectively. There are screws on the fixed place. After removing, install the bracket on it.

3.3. Fill the water tank with water. The motor of the water-cooled spindle is cooled with water, so we fix a water tank on the chassis and add water from the water inlet.

3.4. Connect a total of four power cords on the back of the left chassis of the engraving machine to the three-phase power, and one black wire needs to be connected to the zero wire. Take out the control handle from the accessory box and connect the machine cable to the case, press the main switch, the display of the handle is on, prompt whether to return to the origin, press the OK button to return to the origin, the machine starts to move, the Z axis rises to the top, and the X axis returns On the left, the Y axis returns to the front of the fuselage. Check if the pump is working properly. Pull out the water outlet pipe and see if there is any water flowing out. After the water pump has been working for a long time, there is no water flowing out of the water pipe, then the water pump reverses, and the two lines input to the water pump are arbitrarily adjusted to replace the following to make the water pump rotate forward.

3.5. The dust hood with a brush is inserted from the bottom of the spindle cutting motor. The brush is lower than the position of a knife at the spindle clamping tool. Of course, this position is adjustable, mainly to achieve good vacuuming. effect.

3.6. Install the suction tube. There are three suction tubes, two of the same length and thin, and one section is thick and long. The other end needs to be connected to the vacuum cleaner. There are three suction ports for the vacuum cleaner, one of which is equipped with a sealing cover, and the other two are for taking over the head.