NEW: stepper motor by JVL

A series of step motors with IP67 protection have been designed by JVL for use with the entire range of JVL Step Motor Drivers and Controllers. Torque from 0,5Nm to 8,2Nm. Even shaft sealing can be IP67 for underwater or harsh industrial operation.

Special IP67 sealing at rear end and between stator and flanges

Special Teflon IP67 shaft sealing

Cost-Effective in harsh wet environment

Ideal for food processing, pharmaceutical and chemical industries

A double shaft seal and leak-proof cable entry provide watertight sealing

The material of shaft is stainless steel SUS303/EN 1.4305/AISI303

2 phase motor. 200 step/rev.

High torque-to-inertia for faster start and stop

Rugged design and long life bearings

High power, cooler running, rare-earth magnet design

Exposed-lamination housing, optimized for high torque and smooth, accurate microstepping

NEMA23 (57x57mm), NEMA26(60x60mm) and NEMA34 (86x86mm) mounting

Very short length and very high torque/mm3

High axial and radial shaft load

Cost-effective alternative to servo motors

All motors are D-shaped