NEW: tension meter by Lenox

Tungsten carbide grit cuts through fiberglass, ceramic tile, laminates and other abrasive materials CLEAN CUTTING Carbide grit edge will not snag or chip when cutting thin materials Use standard arbor or SNAP-BACK™ arbor

Maintaining proper water to sawing fluid ratio increases tool life and ensures longer fluid performance EASY TO USE Calibrate with a drop of water, put a small amount of sawing fluid in the refractometer. A quick look through the lens shows the fluid ratio.

Exceptional heat and wear resistance when cutting solid tool steels and tough alloy steels New tooth geometry optimizes cutting efficiency and toughness to resist chipping in harder to cut alloys Lower clearance angle creates a tougher edge Improved chipbreaker eliminates weak points in high stress areas Enhanced edge preparation reduces tip fractures and extends blade ...