With its high bandwidth, flexible bus architecture and integrated tandem drive control, the MC800 sets new standards

As successor of the long-proven MC700, of course the MC800 meets the requirements for all common applications such as: Synchronization Control, Index and Print Mark Control, Rotating Cross Cutter, Flying Saw Control, Rotating Cross Cutter Control, etc. – and this by the latest state-of-the-art.

• Suitable for incremental encoders or sensors with RS422 output or 10-30 V HTL output (differential signals A, /A, B, /B)

• Freely combined with standard SinCos sensors or SinCos encoders with 1 Vpp (format sin+, sin-, cos+, cos-)

• Four fast interrupt based HTL NPN/PNP inputs for control commands

• Two 14 bit analogue inputs with ±10 V, as well as two similar analogue outputs

• OnBoard interfaces: Ethernet TCP/IP, CANOpen, Modbus RTU, RS232/RS485 interface

• Optional interfaces: e.g. ProfiNet, EtherCad, Profibus TCP, DeviceNet etc.

• Snap-on module for standard DIN rails (35 mm C-profile)

• Synchronous process during penetration of the tool and length dependent speed outside this phase

• Optimizing polynomial speed profile to ensure extremely smooth motion and gentle tool treatment for best service life

• High cutting precision, even at high line speeds, due to a max. 2 MHz feed-back frequency of the incremental input or 1 MHz of the SinCos input

• High dynamic response by means of short cycle time (300 µse), therefore accurate cutting results also during change of line speed

• Suitable to operation with all 4-quadrant drives providing a standardized drive communication bus (e.g. SerCos II) or a ±10 V speed input

• Easy setup and commissioning by use of the Windows based operating software (freeware), resulting in successful machine operation within shortest time

• The controller can communicate with external operation terminals as well as HMI via standardized factory communication bus (e.g. Profitnet)