DP500 Leveling Control Agricultural Machinery

Leveling Control of DP500 Agricultural Machinery for Horizontal Angle of Automatic Running Agricultural Machinery Control.

Leveling Control of DP500 Agricultural Machinery for Horizontal Angle of Automatic Running Agricultural Machinery Control. The product is composed of CNC display and dynamic inclination sensor. On the monitor Easily set the threshold of adjusting angle, you can set the speed and amplitude of callback, so as to be able to Hydraulic adjusting speed suitable for each machine. Inclination is integrated in dynamic inclination sensor Instruments and dynamic gyroscopes can output stable horizontal angles at high speeds or turning maneuvers.It has been proved that the adjusting speed is high and the movement is stable by the practical application.

Manual/automatic switching switch: When the switch is in automatic mode, the output of the two switches is automatically adjusted. According to the tilt angle at that time, the real-time output of the leveling signal. When the switch is in manual mode, the output has nothing to do with the current angle, so the output signal needs to be adjusted by pressing the manual button.

The left/right output button is leveled manually: When this button is pressed, the corresponding two switch signals are valid (manual mode).

Output Response (plus) / Output Response (minus) button: two function modes of button setting are as follows (FLASH can be saved);

A: In manual mode, after pressing two buttons for 5 seconds at the same time, it enters and displays the current leveling action threshold set at that time. The digital tube enters the flflashing state, and then press Add or subtract can increase or decrease the alarm value, press, add or subtract one bit, increase or decrease from decimal place, and return to normal working state after 5 seconds without key operation.

B: In manual mode, after 5 seconds of pressing either of the two keys separately, the current zero-return angle is entered and displayed, and the digital tube is in the blinking state.The angle of return to zero can be increased or decreased by pressing add or subtract. If you click, add or subtract one bit. Increase or decrease from decimal place. If there is no key operation after 5 seconds, return to normal work. (Note: The return zero angle should be less than the leveling action threshold, otherwise the return zero angle is invalid. )For example, if the current leveling action threshold is set to 2.5 degrees, it means that if the current inclination is greater than 2.5 degrees, the output switch signal is left, such as the current inclination is less than -2.5.If the current leveling stop threshold is set to 2.0 degrees, it means that the current tilt angle must be less than 2.0 degrees, then the output switch signal will be turned off on the left, but negative.When the angle of inclination is greater than - 2.0 degrees, the output switch signal is turned off on the right.

Set the zero button: Five seconds after pressing this button, set the angle at that time to 0 degrees,Which is saved in FALSH as the benchmark of the follow-up angle.