NEW: electromagnetic feeder by Syntron Material Handling

Syntron® Heavy Duty Electromagnetic Feeders increase bulk handling productivity with controlled high feed rates that improve cost-per-ton handling efficiency. These versatile feeders are capable of handling a variety of materials from the finest powders to large, coarse particles. They are available in ten different models with capacities ranging from 25 to 1600 tons per hour, based on dry sand weighing 100 pounds per cubic foot. Capacities vary depending on drive unit location, material characteristics, material density, trough length and width, trough liner type, feeder installation, skirt boards and hopper transitions.

Syntron® Electromagnetic Feeders require minimal maintenance, as there are no mechanical parts to wear out such as cams, eccentrics, belts and bearings, thus eliminating the need for lubrication. All movement is confined to the heavy duty leaf springs. Electrical components, such as the coil, will provide years of service under normal operating conditions. Dust-tight drive units are standard on all models.

Dependable, flexible controls provide easily adjustable feed rates with instantaneous response. A variety of controls with special control arrangements are available.

Electromagnetic Feeder Features

• Dust-tight and maintenance-free drive units

• Above- or below-deck drive units

• Two-mass, spring-connected, sub-resonant tuned

• High frequency - 3600 VPM at 60Hz

• Stroke - 0.060 inches

• Stroke generated by creating a magnetic field

• Suspension mount, base mount or combination of both

• Bolt-in replacement trough liners

• Multiple-drive unit feeders available