Use of Electronic Feeler gage on power generation applications.

The use of feeler gauge is long, due to the selection of the appropriate set of gauges to reach the gap to be measured, and to the minimum requirement of 2 measurements: 1 go, 1 no-go, & often many more…

The precision of the measurement is closely linked to the operator ability and experience with theses tools

Thin gauges are fragile (0.04; 0.05 mm)

Thicker gauges (above 0.15mm) are however quite strong.

The portable gap measurement system GapmanGen3 from Capacitec, brings a high precision, instantaneous, easy to carry and to use gap analyser system right to the construction site.

It is constituted of an electronic meter and an attached (changeable) sensor, either a thin gap For more information about Capacitec products, please call +33(0)1 43 39 48 68,

email eurosales@capacitec.com, or visit www.capacitec.com (flexible, works with conductive materials) or a rigid spring contact gap sensor (works with any material)

It delivers instantaneous gap values, with a precision greater than 0.01 mm, and min gap over an area can be quickly obtained by moving the sensor other the area to be considered.

For more information about Capacitec products, please call +33(0)1 43 39 48 68,

email eurosales@capacitec.com, or visit www.capacitec.com