Universal testing machine common fault and solution:

Universal testing machine common fault and solution lastest

Universal testing machine common fault and solution:

1) The host power does not light, can not move up and down?

Check whether the power supply circuit of the access test machine is connected normally; whether the emergency stop switch is in the screwed state; whether the power supply voltage of the access test machine is normal; whether the insurance on the machine socket is blown, please remove the spare fuse.

2) After the computer software is online, the message appears to indicate overload?

Check whether the communication line between the computer and the test machine is off; whether the sensor is selected correctly or not; whether the sensor is calibrated or calibrated before the problem occurs when the rubber tensile tester has been tested or operated on the keyboard or not? Correctly change the calibration, calibration, or other information in the hardware parameters.

3) The test machine adopts the double screw in the beam transmission mechanism, the hydraulic cylinder under the home, the installation sample is convenient, the stability is good, the shape is beautiful.The fuel tank adopts the fully enclosed structure, can effectively prevent the dust and other debris into the hydraulic system, thus Improve the reliability of the hydraulic system.

4) test machine host power supply but the device can not move up and down. The solution is to check whether it is 15S (time) after the device can not move, because the host boot needs self-test, probably need 15S time; check the upper and lower limit is appropriate location, there is a certain operating space; check the access test machine Power supply voltage is normal.

more informations:www.haidatestequipment.com