MIXING BUCKET M3 SIDE DISCHARGE WITH ONE-WAY VALVE

No need of a power line

We would like to offer you an alternative solution already in use to avoid the use of the electrovalve, which, especially on telehandlers, implies the installation of a power line for its functioning.

Thanks to the mixing system planned for our mixing buckets with side discharge we can mix the concrete with the oil flowing in one direction. Thanks to the hydraulic locking, made according to our own design and mounted in place of the electrovalve, when we reverse the oil flow, we first open the discharge bottom. Once it has been completed open, the mixing starts again to allow the discharge.

The same operation is needed to close the discharge bottom and restart the mixing. The manual tap at the bucket side is mounted to allow the oil flow to be reversed and consequently the mixing direction when the screw is blocked by a stone.

This cheap solution, by just adding the cost of the manual diverter and of two more hoses), has a great advantage: the mixing bucket can be mounted on every machine, thanks to the absence of an electric system. While almost every skid loader is equipped with a 14pin plug, nowadays lots of telehandlers are not equipped with an electric predisposition

M3 mixing buckets are equipped with bottom and flight in Hardox 450 HBW. The transmission is with chain (along with chain tensioner), with resultant low maintenance costs and a lighter structure if compared to a reduction gear.

The models with side discharge ensure complete safety, as the operator has not to stay under the bucket while positioning the discharge pipe. The mixing buckets with side discharge are equipped with a seal kit with 2 years’ warranty and with anti-wear bolted paddle. The motor is fully protected for a greater durability. The mixing proves to be more homogeneous and requires less power and pressure.

Upon request, it is possible to supply the mixer bucket with a protection grid with hydraulic opening or manual opening with gas springs