CUTTER FOR GASKETS

COD. 9003T

The Texpack® gasket cutter is a device for producing of gaskets with diameters ranging from 80 mm to 1250 mm. Circular gaskets can be produced exactly to size. Any gasket material can be cut: asbestosfree, graphite, rubber, PTFE, PVC, carbon and leather.

Instructions for use

Position the centering pin for the desired gasket diameter and then lock using the special lever

Position the surface (not included)

Lower the cutting blade until the surface has been lightly marked

Fasten the position of the cutting blade and then lock it

Lift the cutting blade using the small handwheel

Make a centering hole in the sheet from which the gasket has to be cut

Position the sheet on the centering pin

ut the gasket by rotating the larger handwheel, after having lowered the cutting blade by the required amount. If the material to be cut has a thickness of more than 3 mm, the use of a surface can be avoided by cutting the sheet through approximately half of its thickness, and then turning it over and carrying out the same cutting operation on the other side of the sheet