NEW: medium-frequency induction heating generator by Ultraflex Power

The Ultraflex UPT-M/AIR family of products is specifically designed for preheating applications, stress relieving or shrink fitting applications.

Air-cooled Induction Heating Systems, with compact and mobile units, easy to use and to move around the work area.

Easy to configure the heating coil using either dry cables or water cooled leads.

Utilize advanced, cost effective induction heating technology with adaptive digital phase control providing very efficient operation in a wide frequency and load ranges.

CE certified with built in safety features (open coil detection, isolation fault protection, over current and over temperature protection).

More information

Details

Ultraflex Power

Keywords

Power supplies

Induction heaters

Associated Trend items

New Induction System installed for Magnetic Nanoparticle Research

Our customer at Sherbrooke University in Quebec, Canada was all smiles as they recently installed a custom UPT-S2 2 kW Induction Heating System. Sherbrooke University will be using this system for magnetic nanoparticle research. The system was modified to operate up to 300 kHz, to give Sherbrooke the desired magnetic field in their research.

Ultraflex Power Technologies has a family of induction systems for nanoparticle research. The original system, the UPT-n5, has 5 kW of power and operates with frequencies from 50 to 450 kHz. The UPT-n2 is a lower power 2 kW system with frequencies from 50 – 250 kHz. Ultraflex is also introducing the UPT-n3, a 3 kW system with frequencies from 30 – 300 kHz. In addition...

More information

Brazing Aluminum to Aluminum

The objective of the application test is brazing Aluminum to Aluminum in less than 15 seconds. We have aluminum tubing and an aluminum “receiver”. The brazing alloy is an alloy ring, and has a flow temperature of 1030F.

Equipment Ultraheat UPT-S5 Power Supply HS-4 Heat Station Induction Coil Materials • Aluminum tube: 0.167” OD, 0108” ID • Aluminum component: ID .1675”, depth .288”, chamfer at top area is 0.2375” ID max • Braze alloy in the form of two-turn alloy ring • Flux Key Parameters Temperature: 1030F Power: 2 kW Time: 14 seconds Frequency 107 kHz Process:...

More information

Induction Braze Carbide Cap to Steel Shaft

Objective of Application Test: Induction Braze Carbide Cap to Steel Shaft. Customer currently uses a torch process, but would like to change to induction to reduce scrap and rework and improve quality of braze.

Equipment UltraHeat UPT-S5 Power Supply HS-4 Heat Station Materials • Carbon steel • magnetic carbide caps • Alloy – EZ Flo 3 paste • Test 1: Shaft Diameter: 0.5” • Test 2: Shaft Diameter: 0.375” • Test 3: Shaft Diameter: 0.312” Key Parameters Test 1 (Shaft Diameter: 0.5”) Temperature: approximately 1450F Power: Pre-curie – 3.3 kW Time: 11 seconds ...

More information

Compare

Remove all

Compare up to 10 products